I would suggest that no more than 14-18volts go into the unit, and don't
use the moto injectors as they are reversed and cause's the unit to hiss
and will burn out the board or the injector in time
if you keep (Ethernet port at kn200) voltage around 12volts, you should
be ok
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Charles Chia Sheng Wu
> Sent: Tuesday, September 30, 2003 11:32 PM
> To: Norm Young; Karlnet Mailing List
> Subject: RE: [Karlnet] KN-200 PoE
>
> actually, no
> due to overheating issues, there's now a power supply range to use
(and
> ONLY
> use)
>
> -Charles
>
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Norm Young
> Sent: Tuesday, September 30, 2003 10:01 PM
> To: Karlnet Mailing List
> Subject: [Karlnet] KN-200 PoE
>
>
>
> I'm trying to power up one of the new KN-200 boards. I'm looking at
the
> PoE
> specs in the User Guide, and it appears that you can use any voltage
from
> 12-48vdc, and any polarity scheme on 4/5, 7/8. So, I thought I'd go
with
> roughly 15vdc, 7/8 positive and 4/5 negative. I'm hoping that this
is
> correct. (If so, it's pretty impressive.)
>
> Norm
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> --
> [This E-mail scanned for viruses by Declude Virus]
--
[This E-mail scanned for viruses by Declude Virus]
|