Robert,
Try a Factory default reload which will take it back to a Std AP load IP and
wireless cards as 802.11b AP's, open network which will give you a starting
point w/o the ethernet interface.
Regards
Ian Hastie
LINKIT
NEW ZEALAND
Subject: [Karlnet] AP-1000 rs-232c port
Is it possible to access an AP-1000 via the RS-232c port on the unit with a
serial or null modem cable & coms software to access unit firmware ?
I have a unit with a stuffed ethernet port, it is running turbocell v4.31 I
was able to access it via a ndis client to the wireless cards I was trying
to reflash the unit with firmware again to try to fix ethernet port when I
forgot to resetup the unit interfaces, so by uploading without doing so I
rendered the wireless cards inactive.
Just wondering if anyone has any ideas that my help ?
Thanks,
Robert
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|