Karlnet
[Top] [All Lists]

Re: [Karlnet] TC on 70km link?

To: Karlnet Mailing List <karlnet@WISPNotes.com>
Subject: Re: [Karlnet] TC on 70km link?
From: "Bruno Lopes F. Cabral" <bruno@openline.com.br>
Reply-to: Karlnet Mailing List <karlnet@WISPNotes.com>
Date: Tue, 13 May 2003 17:08:06 -0300
List-post: <mailto:karlnet@WISPNotes.com>
Hi!

I'm glad to know that someone already did what I'm planning :-)
Hope you don't bother to comment your experience a bit more:

- did you set the RGs to 1/2, 5.5 or 11Mbits?

- do you recall which were the ping averages while getting
the 140KB/sec http transfer?

- english isn't my primary language. Do you mind explain me what
low "fade margin" means?

- I thought the ocean would cause more reflection than
a link over the ground!!

- good to know it survived a storm. on the 660m location, it
rains a lot!!

- I was told that 1.5 meters solid parabolic would be rougly
equal to a 3 meters grid antennae. I'm not sure it is true, but
that should help -- plus the 6dB margin from my 31dBi antennae 
to the 25dBi ones you used ;-)

- solar powered? nice! did you buy it ready or did it yourself? 
did you considered eholic power?

- how did you align that antennaes? GPS? "by-hand" (ping open
and checking the signal report for each RG-1000 through the
config utility)? We never did something so long before!

Thanks for the input!

Cheers
!3runo
from Brazil

Sam Deller - Airnet NZ wrote:
> Hi Bruno,
> About 18 months ago we tried pushing this exact combination to
> the limits as an experiment.
> Solar Powered RG1000 at each end running TC point to point,
> 5m LMR400 cable, 25db parabolic grid, no amplifier.
>
> We achieved 74Km BUT there is a few catches as stated below:-
>
> The test was across the ocean (perfect fresnel clearence) , from
> 1100ft hilltop to 1300ft hilltop. (Havelock North to Wairoa, New
> Zealand)
> Fade margin was very average but it worked through a storm !
> Throughput was in the region of 140KB/sec (HTTP) - FTP is lower.
> RG's in 'Turbocell - no basestations' mode seem to have better throughput
> than any other setting for PtP. The other option is 'Turbocell - Master'
> and 'Turbocell - Slave' but for some reason its slower... due to polling
> maybe ?

<Prev in Thread] Current Thread [Next in Thread>