| To: | "Karlnet Mailing List" <karlnet@WISPNotes.com> |
|---|---|
| Subject: | [Karlnet] WPBASE+ Problems |
| From: | "Nate McLain" <nate@ctrail.net> |
| Reply-to: | Karlnet Mailing List <karlnet@WISPNotes.com> |
| Date: | Wed, 26 Mar 2003 21:26:18 -0600 |
| List-post: | <mailto:karlnet@WISPNotes.com> |
Ok, I have a WPBASE+ and after I have flashed it I just get a Green Power light on LED5. And then 4 Red LEDs on the rest. And I can't scan it with the configurator. If I put it back in base boot mode then it just shows up with the Status of NEW. Like it was never flashed. It is almost like there is something preventing it from being flashed. Does anyone have any documentation on these.... :-D LOL Nate |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Karlnet] New Line of Embedded Systems??, Nate McLain |
|---|---|
| Next by Date: | [Karlnet] WPBASE+ Problems, Nate McLain |
| Previous by Thread: | [Karlnet] WISPCON III, Robert Farrar |
| Next by Thread: | [Karlnet] WET-11 Firmware, Brett Hays |
| Indexes: | [Date] [Thread] [Top] [All Lists] |