We will have some sample boxes at WISPCON. Feel free to bring up your
suggestion to Doug Karl!
Also wanted to back up Tony's statement- plastic is cheap....the molds are
not!
Kevin
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Nate McLain
Sent: Thursday, March 20, 2003 11:25 PM
To: Karlnet Mailing List
Subject: [Karlnet] Simple Plastic Backplates
Are there any plans for KN to sell a simple plastic backplate for the new
boards that are shipping?
It would be nice to be able to have them made out of plastic and have the
ability to isolate the board with the plastic backplate.
Maybe using the same type of setup that was on the RG cases.
That would allow for access to the compact flash socket when you need to get
to it.
I would think that these could be produced by a injector molding shop in
mass quantities at a very cheap price.
Are there any plans for something like this??
Nate
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|