the reason behind having to reboot if you route on your KarlNet APs is due
to the fact that to add new statements, it doesn't take in effect on KNet
APs unless you save config and reboot remote (unlike a cisco, where you can
copy to run & startup config while the router is still functioning)
-Charles
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Michael Painter
Sent: Tuesday, February 18, 2003 4:20 PM
To: Karlnet Mailing List
Subject: Re: [Karlnet] Status of new hardware
----- Original Message -----
From: "Bob Hrbek" <bhrbek@jagwireless.com>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Tuesday, February 18, 2003 11:09 AM
Subject: Re: [Karlnet] Status of new hardware
> I guess your not routing. :) Or ...you planned better than I did.
>
> -bob
I'd appreciate it if you could say a few more words about this.
How would you change your "planning" compared to how you initially did it?
Thanks Bob,
--Michael (Networking dummy)
> ----- Original Message -----
> From: "George Minich" <gminich@toshiba.ca>
> To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
> Sent: Tuesday, February 18, 2003 2:45 PM
> Subject: [Karlnet] Status of new hardware
>
>
> > Hi all,
> >
> > any indication as to when the new Karlnet hardware will hit the streets.
> I
> > am in GREAT need of this gear. If it is not available, I will have to
> > convert. I am running the Trango 5.8 gear in 2 sectors and it really
> > shines. It has been as good as the Karlnet stuff has been for me -
> stable.
> > My Karlnet bridge ran for over 100 days without the need for a reboot.
> >
> > Thanks
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|