Ap-1000 -> Ap-1000....what should it be?
say a 5 mile link, no polling, and say...an SNR on each side of 25 and a
signal of -65dbm at each side. (unamped)
----- Original Message -----
From: "Kevin Knuth" <kknuth@karlnet.com>
To: <karlnet@WISPNotes.com>
Sent: Tuesday, November 12, 2002 8:00 PM
Subject: RE: [Karlnet] KN Throughput
> All,
>
> The actual throuhput is affected by the hardware as well.
>
> An RG has a slower processor than an AP-1000 so it will be a bit slower.
> Processor speed is important because of unbundling the superframe packets.
>
> SO- What hardware are you using exactly??( Charles's question from
earlier,
> he was on the right track).
>
> Kevin
> ____________________________________
> Kevin R. Knuth
> Business Development Manager
> North America
> Corporate Office: 614-822-5275 x130
> Home Office: 260-424-9690
> Cell Phone: 260-402-6086
> Email: kknuth@karlnet.com
> www.karlnet.com
> ____________________________________
>
>
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Bob Hrbek
> Sent: Tuesday, November 12, 2002 8:42 PM
> To: karlnet@WISPNotes.com
> Subject: Re: [Karlnet] KN Throughput
>
>
> I have a PtP karlnet link at the end of a 10 mile trango link. The
Karlnet
> link is about 5 miles and we get about 3.9Mbps but we have a "little"
> frensel clearance issue ;)
>
> NOC--trango~~~~~~~~~~~~~~~~~~~~~KN~~~~~KN 15miles total; 3.9Mbps. The
> best I've ever seen from any 802.11b stuff is 4.5Mbps and that was like a
> 3/4 mile shot w/ 24dbi grids on each end.
>
> -bob
>
>
> ----- Original Message -----
> From: "Nate McLain" <nate@ctrail.net>
> To: <karlnet@WISPNotes.com>
> Sent: Tuesday, November 12, 2002 7:32 PM
> Subject: RE: [Karlnet] KN Throughput
>
>
> > We have links that run 4-5mbps.
> >
> > Nate
> >
> >
> > -----Original Message-----
> > From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> > Behalf Of John Maxwell
> > Sent: Tuesday, November 12, 2002 7:26 PM
> > To: karlnet@WISPNotes.com
> > Subject: [Karlnet] KN Throughput
> >
> >
> > Anyone out there know the actual throughput that we can get on a KN TC
PtP
> > link? To this point, I've only seen about 2mbps at the most. I
> understood
> > that they could do about 5-6mbps.
> >
> > Any words of wisdom?
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> >
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|