how many clients do you have on the other side of the SEC client?
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Bob Hrbek
Sent: Tuesday, June 25, 2002 11:32 PM
To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] Can't open some AP's
I have the same problem connecting via a SEC client to an AP-500. I can't
ping the AP-500's lan interface from every client behind the routed SEC
client. Some can ping it....others can't. If I reboot things (SEC Client,
AP) sometimes I can ping it again.
Almost as if the ARP tables aren't right. I haven't really looked into it
that much.
Here is the config though.......
<lan 10.1.2.1>-SECclient -<wlan 10.1.1.2>----[ ~~~ ]---<wlan>-AP500-<lan
10.1.1.3>
SecClient:
Wlan: 10.1.1.2 GW: 10.1.1.1
Eth: 10.1.2.1
AP-500
eth: 10.1.1.3 GW: 10.1.1.1
Most machines on the 10.1.2.x segment can ping the AP-500, some can't.
-bob
----- Original Message -----
From: "Mark Reisch" <markr@i2k.com>
To: <karlnet@WISPNotes.com>
Sent: Tuesday, June 25, 2002 11:11 PM
Subject: [Karlnet] Can't open some AP's
> I have several access points running Karlnet.
>
> A couple I can not open remotely, they can only be read if conncted to
> physical Lan network.
>
> Any suggestions ?
>
> Thanks
>
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|