I'm checking on the SEC support. I've talked with Doug Karl, since he had
to do some things with SEC that weren't supported in the Prism firmware. He
thinks that they wouldn't work in bridging mode, but should work in NAT or
Routing mode. I'm going to have our guys take a closer look at the radios
and can give everyone a better answer then.
I will be at WCA tomorrow and Weds with Kevin Knuth. Look forward to seeing
some of you in Boston.
Doug Harman
KarlNet, Inc.
525 Metro Place North
Suite 100
Dublin, OH 43017
614 822-5275 x 123
614 822-0024 fax
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Tony
> Sent: Saturday, June 22, 2002 11:39 AM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] AP1000 with non-lucent cards
>
>
> Larry
>
> This is correct at this time, I have not received a update on whether or
> not SEC will be supported on the Prism chip. Doug any comments on
> this??
>
> Sincerely
> Tony Morella
> Demarc Technology Group
> Office: 908-996-7995
> Cell: 908-246-9170
> Fax: 908-847-0202
> email: tony@demarctech.com
> http://www.demarctech.com
> Wireless Solution Provider
>
>
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> On Behalf Of Larry Yunker
> Sent: Friday, June 21, 2002 9:24 PM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] AP1000 with non-lucent cards
>
>
> So you are stating that you can't even run 100mw cards in SEC mode in a
> PC running a karlnet flash-rom kit? This sounds worse than I had
> thought. I was really hoping to stay with Karlnet for it's nice client
> signal monitoring capability. But I really need to get cards with more
> juice than 35mw and I really DON'T want to resort to AMPs.
>
>
> ---------- Original Message ----------------------------------
> From: "Tony " <tonylist@wwwbiz.com>
> Reply-To: karlnet@WISPNotes.com
> Date: Fri, 21 Jun 2002 20:06:08 -0400
>
> >Larry
> >
> >Your request is for SEC which is not an option under the prism cards,
> >SEC only works for Orinoco cards.
> >
> >Sincerely
> >Tony Morella
> >Demarc Technology Group
> >Office: 908-996-7995
> >Cell: 908-246-9170
> >Fax: 908-847-0202
> >email: tony@demarctech.com
> >http://www.demarctech.com
> >Wireless Solution Provider
> >
> >
> >-----Original Message-----
> >From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> >On Behalf Of Larry Yunker
> >Sent: Friday, June 21, 2002 4:33 PM
> >To: karlnet@WISPNotes.com
> >Subject: RE: [Karlnet] AP1000 with non-lucent cards
> >
> >
> >Hmm... I could have sworn that there were a few guys that had the
> >AP-1000's running in Turbocell mode with the prism cards.
> >
> >Here is what I need:
> >
> >Some sort of hardware suitable for tower mounting (lightweight, weather
>
> >resistant, Power-over-ethernet, etc, etc)
> >
> >Karlnet SEC BASE
> >three 100mw Cards (to run 3 sector antennas)
> >one standard 35mw Lucent Silver/Gold Card (to run backhaul to NOC
> >cross-polarized and 25ft vertical separation from the sectors)
> >
> >Does anyone market a 4-PCMCIA-slot SBC's with Karlnet firmware? Or
> >maybe I'll just need to get two 2-PCMCIA slot SBC's with Karlnet.
> >
> >Anyway... if Karlnet has any suggestions or if any vendors would like
> >to contact me off-list, I'm looking for a solution!
> >
> >Thanks,
> >Larry
> >
> >
> >---------- Original Message ----------------------------------
> >From: "Support" <support@karlnet.com>
> >Reply-To: karlnet@WISPNotes.com
> >Date: Fri, 21 Jun 2002 15:47:59 -0400
> >
> >>The higher output radios don't work in the AP-1000. The hardware
> >>isn't
> >
> >>setup to handle the power.
> >>
> >>Doug Harman
> >>KarlNet, Inc.
> >>525 Metro Place North
> >>Suite 100
> >>Dublin, OH 43017
> >>614 822-5275 x 123
> >>614 822-0024 fax
> >>
> >>> -----Original Message-----
> >>> From: karlnet-admin@WISPNotes.com
> >>> [mailto:karlnet-admin@WISPNotes.com]On
> >>> Behalf Of Larry Yunker
> >>> Sent: Friday, June 21, 2002 11:25 AM
> >>> To: karlnet@WISPNotes.com
> >>> Subject: [Karlnet] AP1000 with non-lucent cards
> >>>
> >>>
> >>> Has anyone had any luck running the AP1000 in 802.11b mode with
> >>> non-lucent cards. I'm hoping to find a 100mw solution, but it has
> to
> >
> >>> be 802.11b mode NOT Turbocell.
> >>>
> >>> Does the Karlnet SEC Base software let me do this?
> >>>
> >>>
> >>> _______________________________________________
> >>> Karlnet mailing list
> >>> Karlnet@WISPNotes.com
> >>> http://lists.wispnotes.com/mailman/listinfo/karlnet
> >>>
> >>
> >>_______________________________________________
> >>Karlnet mailing list
> >>Karlnet@WISPNotes.com
> >>http://lists.wispnotes.com/mailman/listinfo/karlnet
> >>
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|