Karlnet
[Top] [All Lists]

RE: [Karlnet] AP1000 with non-lucent cards

To: <karlnet@WISPNotes.com>
Subject: RE: [Karlnet] AP1000 with non-lucent cards
From: "Tony " <tonylist@wwwbiz.com>
Reply-to: karlnet@WISPNotes.com
Date: Fri, 21 Jun 2002 20:06:08 -0400
List-post: <mailto:karlnet@WISPNotes.com>
Larry

Your request is for SEC which is not an option under the prism cards,
SEC only works for Orinoco cards.

Sincerely
Tony Morella
Demarc Technology Group
Office: 908-996-7995
Cell: 908-246-9170
Fax: 908-847-0202
email: tony@demarctech.com
http://www.demarctech.com
Wireless Solution Provider


-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
On Behalf Of Larry Yunker
Sent: Friday, June 21, 2002 4:33 PM
To: karlnet@WISPNotes.com
Subject: RE: [Karlnet] AP1000 with non-lucent cards


Hmm... I could have sworn that there were a few guys that had the
AP-1000's running in Turbocell mode with the prism cards.

Here is what I need:

Some sort of hardware suitable for tower mounting (lightweight, weather
resistant, Power-over-ethernet, etc, etc)

Karlnet SEC BASE
three 100mw Cards (to run 3 sector antennas)
one standard 35mw Lucent Silver/Gold Card (to run backhaul to NOC
cross-polarized and 25ft vertical separation from the sectors)

Does anyone market a 4-PCMCIA-slot SBC's with Karlnet firmware?  Or
maybe I'll just need to get two 2-PCMCIA slot SBC's with Karlnet.  
 
Anyway... if Karlnet has any suggestions or if any vendors would like to
contact me off-list, I'm looking for a solution!

Thanks,
Larry


---------- Original Message ----------------------------------
From: "Support" <support@karlnet.com>
Reply-To: karlnet@WISPNotes.com
Date: Fri, 21 Jun 2002 15:47:59 -0400

>The higher output radios don't work in the AP-1000.  The hardware isn't

>setup to handle the power.
>
>Doug Harman
>KarlNet, Inc.
>525 Metro Place North
>Suite 100
>Dublin, OH 43017
>614 822-5275 x 123
>614 822-0024 fax
>
>> -----Original Message-----
>> From: karlnet-admin@WISPNotes.com 
>> [mailto:karlnet-admin@WISPNotes.com]On
>> Behalf Of Larry Yunker
>> Sent: Friday, June 21, 2002 11:25 AM
>> To: karlnet@WISPNotes.com
>> Subject: [Karlnet] AP1000 with non-lucent cards
>>
>>
>> Has anyone had any luck running the AP1000 in 802.11b mode with 
>> non-lucent cards.  I'm hoping to find a 100mw solution, but it has to

>> be 802.11b mode NOT Turbocell.
>>
>> Does the Karlnet SEC Base software let me do this?
>>
>>
>> _______________________________________________
>> Karlnet mailing list
>> Karlnet@WISPNotes.com 
>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com 
>http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet


<Prev in Thread] Current Thread [Next in Thread>