On 6/4/02 9:48 AM, "Leszek Olszewski" <leszek@oslink.pl> wrote:
> Hello,
>
> Is there a Prism2 card that works with Karlnet, has two antennas connector
> and allows separation to connect transmit antenna on one connector and
> receive to the other? Cisco cards allow that but when I tried booting
> RG-1100 with one it just hangs. On the other hand it boots fine with
> Netgear and Proxim cards which I believe are Proxim2. None of them allows
> signal send/receive separation though (or am I wrong)?
>
> Any suggestions, pretty please? ;)
>
Turbocell will support Intersil 2.0 and 2.5 and Lucent cards. Cisco is a
VERSION of 2.0, but has been Ciscotized (won't work).
Also it helps if you flash the RG with the .bin while the 2.x card is in the
unit some have said...
> Regards,
> Leszek
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
--
Scott Stevens
800-815-4682
scott@scottstevens.net
orders@scottstevens.net
support@scottstevens.net
"Lucent, Karlnet, Alvarion, SmartBridge, Panels, Grids,
Towers, WMUX, Wi-LAN, Licensed, WaveRider, Know How, ..."
|