I have sec client and ap-plus on 2
ap-1000 using 3 silver cards. The ap-plus is running
mobile router on the a card and 802.11b on the b card.
I would like to straight bridge the 2 aps but when I
turn on bridging it works for maybe a minute and dies. When it dies I cant ping anything the two aps or
my gateway. I have tried ip routing with separate non
public ips on the? different interfaces but nothing. The
weird part is when I do a wireless link test from config
the only way the ap plus sees the client is through
the 802.11b interface not not the ap-plus
\ mobile router on card A. If I turn off the b interface they will not showup in the wireless link test.?? FYI: both the ap=plus and sec client are
version 4.02 and all firmware has been updated.?
Any help is greatly appreciated. Will