Use the switch " -enet" on the command line when you issue the ct.exe command.
Have both computers connected to the same network (LAN).
Make she one computer is station 1 and the other a different number on the
setup on the machines.
LPT keying and COM CAT will be same as under DOS. Choose Telnet for spotting
net interface. Make sure you LAN has internet access for the spots.
Sent from my Verizon Wireless Phone
----- Reply message -----
From: "Bob Shohet, KQ2M" <kq2m@kq2m.com>
To: "CT" <ct-user@contesting.com>
Subject: [ct-user] Setting up CT WIN on WIN XP
Date: Thu, Nov 14, 2013 2:38 pm
Hi,
I have used CT DOS (CT 9.65) and WIN 98 computers for years but now
I am going to set up two “test” WIN XP computers to get familiar
with CT WIN and other programs.
To start, I would like to use two WIN XP computers which both
have 2 (COM) serial ports and 1 (LPT) parallel port.
I would like to be able to key the FT1000MP with the computer
and have the two computers networked to each other. I assume that
the keyer interface with the LPT port that worked with CT Dos should
also work with CT WIN?
I have read over all the information on CT 10 (which I assume is
CT WIN?) but I am not clear on how to do the setup on the computers
and what commands to put in the files and where to put them.
Is someone willing to help me with this off reflector?
Thanks in advance!
73
Bob Shohet, KQ2M
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|