When interfacing with my Omni VI, recording of the rig frequency by CT
is the most important part of the RS-232 communication for me.
Controlling the frequency of the rig from CT is much less important,
because I would rather turn knobs than push buttons. Even so, it would
be nice to have the control of the radio work a little more
conveniently. When I enter a frequency into the callsign field in CT the
rig does go to that frequency and it also turns off whatever 6.3 MHz IF
filter selection I had made, and it turns off the N-1 9 MHz IF filter.
Strangely, if the N-2 9 MHz filter is selected, it does not turn that
off. Is there a way to edit the data stream sent to the radio by CT, so
that I can control the radio frequency without changing the filter settings?
DE N6KB
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|