CT-User
[Top] [All Lists]

Re: [ct-user] CT "wipe" function

To: Ted Bryant <w4nz@comcast.net>
Subject: Re: [ct-user] CT "wipe" function
From: Alan Zack <k7acz@cox.net>
Reply-to: k7acz@cox.net
Date: Thu, 08 Dec 2005 13:27:27 -0800
List-post: <mailto:ct-user@contesting.com>
Or F-11?

Ted Bryant wrote:

>Why not just use ALT-W or Alt-F8 to wipe instead?
>
>73 Ted W4NZ
>
>-----Original Message-----
>From: ct-user-bounces@contesting.com
>[mailto:ct-user-bounces@contesting.com]On Behalf Of Henry Pfizenmayer
>Sent: Tuesday, December 06, 2005 11:20 PM
>To: ct-user@contesting.com
>Subject: [ct-user] CT "wipe" function
>
>
>I would like to re- map the "wipe" key on my laptop because it is right 
>above the"enter" key but when I try to re map it , it appears that 
>particular key is not re-mappable . Is this correct ???
>
>This is probably covered somewhere but I have missed it.
>
>I did finally discover last week that when I accidentally wipe a qso , if I 
>have not typed anything else , I can use the "page up" key and the qso 
>reappears . I have not tested this extensively yet however.
>
> Thanks _ Hank K7HP 
>
>
>
>_______________________________________________
>CT-User mailing list
>CT-User@contesting.com
>http://lists.contesting.com/mailman/listinfo/ct-user
>CT on the web:  http://www.k1ea.com/
>_______________________________________________
>CT-User mailing list
>CT-User@contesting.com
>http://lists.contesting.com/mailman/listinfo/ct-user
>CT on the web:  http://www.k1ea.com/
>
>
>  
>

-- 
Alan Zack
Amateur Radio Station K7ACZ
Las Vegas, Nevada, USA
Quality Engineer, The Boeing Company, Retired
Aviation Chief Warrant Officer, U.S. Coast Guard, Retired
U.S. Coast Guard, Always Ready, Always There
Every hour, Every day, Around the Clock and Around the World
SEMPER PARATUS 
http://gocoastguard.com


_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web:  http://www.k1ea.com/

<Prev in Thread] Current Thread [Next in Thread>