I think the Ten-Tec control interface is an Icom clone..... try different
Icom selections to see if one works. The most significant difference
between the various Icom radio selection is going to be the hex address, so
if you know the hex address of your Orion, select the Icom model with the
same address and it will probably play. Below is a list of Icom radio
addresses except the recent 7x6 flavor models (706, 746, 756).
Model Hex Address
725 = 28
735 = 04
737 = 3C
751 = 1C
761 = 1E
765 = 2C
775 = 46
781 = 26
73, de Hans, K0HB
--
http://home.earthlink.net/~k0hb
> [Original Message]
> From: Bill Tippett <btippett@alum.mit.edu>
> To: <ct-user@contesting.com>
> Date: 11/5/03 7:55:51 PM
> Subject: [ct-user] Ten-Tec Orion
>
>
> Please consider support for Ten-Tec Orion. I used this radio in the CQWW
> SSB and its front-end performance far exceeded anything I've used before
> (TS-930S and FT-1000MP). Would be a shame to be forced to move to another
> program after using CT for over 15 years.
>
> 73, Bill W4ZV
>
> _______________________________________________
> CT-User mailing list
> CT-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/ct-user
> CT on the web: http://www.k1ea.com/
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|