Just downloaded a copy of CtWin 9.91.001, and during initial setup, if
I've configured my IC-751, I get "Bad radio type defined" when I hit
"Ctl-Enter" to leave the "Information Sheet" and continue setup; it never
gets to the "Communications Setup" screen.
Also, assuming I can get past this, comments for other radios suggest
that CT doesn't poll the radio, but requires that the UX-14 interface be
placed in "tranceive mode" so that it automatically transmits any mode
or frequency change from the radio.
Unfortunately, Icom's "Troubleshooting Guide" for the IC-751A documents
an "incompatibility" that requires tranceive mode be turned off.
Certainly not the end of the world, but I guess I won't be able to monitor
the radio from CT.
--
Bert Hyman | St. Paul, MN | bert@visi.com
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|