Jeff,
I'm using earlier version of CT. I think it's 9.80 or 9.88.
Everything works just fine.
Regarding QTC - you can either resend it by pressing "-" or just wipe the call
in
the callsign field, get out by pressing Ctrl-L and start all over again. I don't
know the better way. Would be happy to learn better technique of doing that, if
any.
Regards,
Yuri VE3DZ
> #1) Radio control for TS830S did not work. I know my interface box works
> because it works with NA .
>
> #2) Serial numbers jump to 001. I figured out this happens when you log
> out of the program and start it again. There is a little known command
> SETSERIAL that resets the numbers. We had this same problem at NQ4I
> during WPX SSB.
>
> #3) The log kept switching to 20 meters everytime I logged a QSO - no matter
> what band I was on. I figured out later that if I rebooted the computer
> and reset the program for the NONE for radio control and removed the
> setup for the COM port back to NONE it stopped doing this.
>
> Anyone else ever experienced any of these problems ??? Thanks.
>
> Jeff KU8E
>
> PS - Does anyone know if there is a way to move back to the previous QTC after
you have pressed the + button ???
>
|