I was asking my self the same question, So I looked around a bit
on the byterunner site. Seems that they have a program called
VSEMUIO the allows to card (a PCI card) to run under DOS. It creates
virtual ports that look like real ports to the Application.
Sounds pretty nice. I'm tempted to get one of the cards just to
see how it works.
I would like to see comments from those that are doing this as to the
configuration (what drivers do you load, what order etc...)
Dan
-----Original Message-----
From: owner-ct-user@contesting.com
[mailto:owner-ct-user@contesting.com]On Behalf Of Jim Reisert AD1C
Sent: Tuesday, February 27, 2001 00:00
To: Dave Sublette; John Bednar
Cc: CT-USER@contesting.com
Subject: Re: [ct-user] PCI port card & DOS CT
Are you using this in a DOS-only environment like CT requires?
How does CT then sort out all the devices signalling on this one IRQ?
73 - Jim
On Sun, 25 Feb 2001 12:28:25 -0500, Dave Sublette K4TO wrote:
>
>I am runningthe byterunner four port card quite successfully. Yes it
>does use only one IRQ and runs all four ports on that one IRQ.
--
Jim Reisert AD1C, 7 Charlemont Court, North Chelmsford, MA 01863
USA +978-251-9933, <jjreisert@alum.mit.edu>, http://www.ad1c.com
--
WWW: http://www.k1ea.com/
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
Problems: owner-ct-user@contesting.com
--
WWW: http://www.k1ea.com/
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
Problems: owner-ct-user@contesting.com
|