and you do have the rig set as radio 1, no?
and your comtsr does appear to be running...
GL
Jim, K4OJ
----- Original Message -----
From: "Jim Brannigan" <jbrannig@optonline.net>
To: <ct-user@contesting.com>
Sent: Thursday, November 23, 2000 1:37 PM
Subject: Re: [ct-user] Problem interacting with Ten-Tec OmniVI
>
> Bernie,
> Make sure that CDe is ON.
> Also CT has always been a little flaky with my OMNI VI
>
> Jim
>
> >
> > I'm trying to set up ct9.53 to work with a TenTec Omni VI. The setup
> works ok
> > with 9.37b, but with 9.53 changing bands in CT is not reflected on the
> radio.
> > (The message 'radio not echoing') appears in CT. If band/frequency are
> changed
> > on the radio, the changes are reflected in CT, so there is some
> communication,
> > and as I said, it does work ok with 9.37b. Any suggestions would be
> > appreciated.
> >
> >
> >
> >
> > Bernie Gardner, W1AZ
> > bernieg1@mediaone.net
> >
> > --
> > WWW: http://www.k1ea.com/
> > Submissions: ct-user@contesting.com
> > Administrative requests: ct-user-REQUEST@contesting.com
> > Problems: owner-ct-user@contesting.com
> >
> >
>
>
> --
> WWW: http://www.k1ea.com/
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> Problems: owner-ct-user@contesting.com
>
>
--
WWW: http://www.k1ea.com/
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
Problems: owner-ct-user@contesting.com
|