The baud rate setting of the TSR *DOES NOT MATTER* - EVER. I wish Ken
would remove this parameter.
The only place the baud rate matters is inside CT in the COM port setup.
- Jim
At 10:22 AM 11/17/00 -0500, John Scott wrote:
>You do not state what model of MFJ TNC you're using. I have a MFJ-1270C
>with firmware release level 2, version 2.0 release 2.2 dated 11/11/95
>that works just fine.
>I note in your note you've designated 4800 bits per second via the TSR.
>I presume that the dip switches on the TNC are set the same. If your
>serial port will support it, I would suggest setting the TNC for 9600
>and set the TSR for the same.
--
Jim Reisert AD1C <jjreisert@alum.mit.edu>
http://www.ad1c.com/
--
WWW: http://www.k1ea.com/
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
Problems: owner-ct-user@contesting.com
|