The code to read the FT847 mode is not in there yet.
- Ken
-----Original Message-----
From: owner-ct-user@contesting.com [mailto:owner-ct-user@contesting.com] On
Behalf Of Robert J. Curci
Sent: Tuesday, February 15, 2000 11:11 PM
To: AEL; ct-user@contesting.com
Subject: Re: [ct-user] FT-847
I'm glad to see the support for the FT-847. Although it doesn't work 100%.
It does change bands just fine, whether from CT or the radio. They both
update. The spots with ALT-J work fine too. But.....
The mode doesn't switch. When I press the cw switch on the radio, CT stays
in ssb mode. When I change to cw in CT, the radio stays wherever it was and
then I can't get CT to go back to ssb unless I exit and restart CT.
My settings were:
FT847 9600, n82 no flow control
CT was in FD mode.
I'll experiment with the other contests to see if it's global.
73 de Bob
n2xr
----- Original Message -----
From: "AEL" <nq3a@steelcity.net>
To: <ct-user@contesting.com>
Sent: Tuesday, February 15, 2000 11:36 PM
Subject: [ct-user] FT-847
>
> I have not been able to get my FT-847 to work with CT-only get radio
> time-out
> I have upgraded to ver 9.48 and am using null-modem 9-pin serial cable
> My comstr1 settings are: -b9600 -n82
> FT-847 menu #37 set for 9600
> Ct runs perfect with my FT-1000 with TNC & Radio Control
> What am I missing with the FT-847?
> Art-NQ3A
>
>
> --
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> WWW: http://www.k1ea.com/
> Questions: owner-ct-user@contesting.com
>
>
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.k1ea.com/
Questions: owner-ct-user@contesting.com
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.k1ea.com/
Questions: owner-ct-user@contesting.com
|