I also tried CTWIN 945, here are my comments.
OS Win98
-------------------------
On Start:
Get error window:
CW Port Error
Error Opening DriverAgent
LPT1 Keying would not work.
I found that the parrallel port was set to ECP mode (in the bios), I changed
it to Normal and then the error message went away and keying worked.
---------------------------
Also noted : Memory Left for 0 more contacts message
-------------------------------
I get this message when closing CT if I have
a radio selected IC-756 and comport programmed to it.
Radio control is strange, change's made at the radio
affect CT properly, changes made in CT (band/freq) are
not sent to the radio.
CT caused an invalid page fault in
module CT.EXE at 015f:00429fe8.
Registers:
EAX=00000102 CS=015f EIP=00429fe8 EFLGS=00010246
EBX=00000008 SS=0167 ESP=0248ff18 EBP=0248ff64
ECX=00000000 DS=0167 ESI=01f11d38 FS=33c7
EDX=bffc9490 ES=0167 EDI=bff92be9 GS=0000
Bytes at CS:EIP:
8b 01 ff 50 10 8b d8 83 fb ff 75 06 5e 33 c0 5b
Stack dump:
01f11d38 00000008 01f11d38 00429fc3 816c3e80 01ee1e80
004bdb2f 01f11d38 00000000 00000000 00000002 00000000
01efbdd0 00000000 00429fb0 0000ffff
--------------------------------
The sec.dat file is not provided in the install, so
a sweepstakes setup fails. (added file and then works ok)
---------------------------------
TNC control worked ok.
--------------------------------
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.k1ea.com/
Questions: owner-ct-user@contesting.com
|