Good news! I now have the radios physically connected to the PCs and all is
OK .... the lesson is that CT defaults to 20m if it cannot find the radio
connection.
73
Brian ZL1AZE
----- Original Message -----
From: Brian & Lynn Miller <BRIANMILLER@xtra.co.nz>
To: <CT-USER@contesting.com>
Sent: Monday, 27 September 1999 23:22
Subject: [ct-user] WPX BAND CHANGE PROBLEM
>
> I have just encountered the band change problem mentioned in a previous
post
> by Bob KQ2M.
>
> Our configuration is CT 9.40 configured for WPX MM category, K1TTT TSR
> Ethernet network and FT1000MP radios
>
> Everything appears to work fine except that CT logs all calls against 20m
> regardless of which band is actually in use. This problem is only evident
> AFTER selecting the FT1000MP radio in setup ..... if the radio is not
> selected then there is no problem.
> I have also tried version 9.39 and it exhibits the same problem.
>
> Has anyone managed to find a solution or workaround for the problem? Note
> that I do not have the radios to the computers yet - does connecting the
> radios help? Maybe version 9.42 will address this issue?
>
> Thanks
>
> Brian Miller ZL1AZE
> Registered Electrical Engineer
> 67 Hornsey Road
> Melrose
> Wellington
> New Zealand
>
> Tel +64-4-387-9081
> E-mail: brianmiller@xtra.co.nz
>
>
>
>
> --
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> WWW: http://www.k1ea.com/
> Questions: owner-ct-user@contesting.com
>
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.k1ea.com/
Questions: owner-ct-user@contesting.com
|