I have seen this queston asked before but I have never seen a public answer.
When I start CT using VGA mode, I have a problem when I exit the program.
The PC screen stays in VGA mode and only uses half the screen. I also get a
message that says something to the effect, "ANSI.SYS needs to be
installed". I have to re-boot the PC to get back to normal monitor mode.
I have the ANSI.SYS program, so the presence of that file isn't enough to
fix this. I must need to do something more?
I am running a 386-SX and CT 9.39.
Thanks.
73, Richard
k5na@texas.net
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|