i haven't tested 9.3x yet but that has always been confusing for new
operators running m/m with ct. the basic guidelines are:
1. the serial number on the line where you enter the qso is the one to
send.
2. the serial number that scrolls up in the log is to be ignored.
3. don't use rmdupes, or the one to remove your own call from the log.
the serial numbers printed in the log will be ok.
Henry Heidtmann wrote:
>
> Is there a switch for CT to send packet info and mult info to all
> stations while showing only that single station's log? Looking into a
> M/M for WPX and noticed this past weekend in the NC QSO (I ran CQP.DAT
> with NC Counties) that serail numbers would change with 2 stations
> logging at the same time- Didnt see anything in the manual-
> See you this weekend sporadically-
> Henry, N4VHK
> W4NC/W4WS Contest Crew
>
> --
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> WWW: http://www.contesting.com/ct/
> Questions: owner-ct-user@contesting.com
--
David Robbins K1TTT (ex KY1H)
k1ttt@berkshire.net or robbins@berkshire.net
http://www.berkshire.net/~robbins/k1ttt.html
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|