Jeff
Can you describe it to me (physical layout). If it is the one on the tiered
case, flat membrane switches and the 5 Pin Din connector on the back? I was
able to get it to work.
The 4 memory switches on the panel ground when you push the button.
You need to open the case and find the 'hot' (not the ground side) of each of
the 4 memory locations. You can then use the circuit in the CT user manual and
the parallel port (not to mention a couple of transistors-resistors) to ground
the hot side. If memory serves me correctly, they went to a ribbon connector.
Shouldn't take to much time to find with an OHM meter.
I did it a number of years ago and it worked fine. I was able to do all the
interface in the case and just ran the cable to the parallel port. It took me
about 2 hours of hacking around.
Mike VA3MW
At 13:41 98-12-21 , Stuparits, Jeff wrote:
>
>Anyone have a schematic for the old Neltech DVK-100. I am trying to
>interface one to CT for a Multi-Multi station. (Yes, They are old but they
>work!)
>
=================================================
Mike Walker VA3MW
Corbeil Contest Club
http://www.qrz.com/wrad/directory.cgi?VA3MW
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|