I had the same problem.
73 Stan, W3INK
At 09:04 AM 4/23/98 -0400, you wrote:
>I was just setting up 9.36 for the June VHF Contest and ran into a small
>problem. It appears that CT is initialized for 20M.
>
>If you make your first log entry on 2M, you get an "Out of Band! 14000000"
>message, also if you do an ALT-F4 you get the message "On Spot Freq: 14.0".
>
>IF the first entry is on 50 Mhz or 222 Mhz, NO PROBLEM !!! Any contacts on
>2M after the first Log entry are OK!!!
>
>My solution is to log the first entry, if it is a 2M contact, as a 6M
>contact and then go back and change the Band to 144 Mhz.
>
>Not a big problem if you know the "work around", but in the middle of a
>contest it could WASTE quite a bit of time.
>
>Beware and Be Warned !!! This is a GOOD reason to check a new software
>Version out ahead of time, not in the Heat of Battle.
>
>73 es GL
>Bob - WA1OFR - FN42ma
>
>
>--
>Submissions: ct-user@contesting.com
>Administrative requests: ct-user-REQUEST@contesting.com
>WWW: http://www.contesting.com/ct/
>Questions: owner-ct-user@contesting.com
>
Stan Staten, w3ink
sstaten@netkonnect.net
http://www.qsl.net/w3ink/
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|