Hi all,
I'm having a radio control problem with 936...
I've tried both releases of 936 with cold boots....
Just downloaded 936 again, some of the buggy stuff I've seen in 9.3x is
gone, the
jumping freqs while tuning past the highest spotted freq etc.
But when I go to either the packetcluster callouts window or the bandmap
window and scroll up or down, the frequency comes up fine in the message "On
Spot Freq: " but the radio goes a couple hundered kc higher, out of band
even....ie:
when trying to jump to 14204.5 in the bandmap from 14177.0 the radio goes to
14394.0
I then have to manually tune the radio down to get back in the band before I
can jump again.
when trying to jump from 14172.0 to 14196.3 in the callouts window the radio
goes to 143-6.3 (yes a dash!)
from 14190.0 to 14243.0 in callouts radio goes to 143-3.0
14218.0 to 14204.5 in callout > 143c4.5
14326.0 to 14176.0 in callouts >143-6.0
14204.0 to 21282.9 in callout> 21402.0
21402.0 to 21007.3 in callouts >213-7.0
from 21392.0 to 21282.9 in bandmap to 21392.9
from 14336.6 to 14196.3 in bandmap to 14486.3
from 14161.0 to 14212.0 in bandmap to 143-2.0
radio is a icom 735 and no changes to interface or computer (a 386 dx 25)
all works fb in prior versions...
Hope someone has some ideas....
73 Scott
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|