Please don't just reply direct. Others might need the answer as well.
Just where is the Radio 1 / Radio 2 switch for v 9.3x and above now
located ?? LPT 1 or LPT 2 ?? Which pin(s) ?? Where is this
documented ? Are the pin outs now in agreement amongst CT, NA, and TR ?
thanks & 73 James / k1sd
> ----------
> From: Healy, Rus
> Sent: Wednesday, November 26, 1997 10:28 AM
> To: 'ct-user@contesting.com'
> Subject: [ct-user] Serial/parallel port Qs
>
> I have a problem using two-radio mode with CT 9.31. I normally send CW
> from LPT1. However, I think in some fairly recent release, CT began
> activating the same signal on LPT1 that it uses to signal an external
> device that you've selected Radio 2. This is a big hassle, since
> whenever I do an Alt-. to go to rig 2, the selected radio goes
> key-down.
>
> The CT web page says that the second-radio bit is only present on
> LPT2,
> but this is not the case. I have two serial ports and one parallel
> port
> in my radio computer, and I'd like to key the radios using the LPT1
> port
> and control one of them with each serial port. Right now it looks like
> I'll have to build another COM port keying cable, key the radios from
> one of the COM ports and control only one of the radios using the
> other
> COM port. :-(
>
> Any ideas?
>
> *Please reply direct.* TU.
>
> --73, Rus, NJ2L
>
> --
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> WWW: http://www.contesting.com/ct/
> Questions: owner-ct-user@contesting.com
>
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|