Hi,
I'm trying to install a Network Interface Card in a 386 PC that has a K1EA
DVP board installed. According to the DVPTSR, the DVP board is configured
as IRQ=7 and base address=308H. When I configure the NIC to IRQ=10 and
address=300H, the card fails its loop back test and cable connect test.. If
I remove the DVP card from the computer, the NIC passes both tests.
Looks like I need help from someone who understands bus addressing and
interrupts better than I do. Any help would be appreciated.
73 de Bruce, WA7BNM (bhorn@netcom.com)
--
Submissions: ct-user@ve7tcp.ampr.org
Administrative requests: ct-user-REQUEST@ve7tcp.ampr.org
WWW: http://www.ve7tcp.ampr.org/Software/ct
Questions: owner-ct-user@ve7tcp.ampr.org
|