The end of this message contains release notes for CT 9.23 which is
available NOW on the CT BBS (508-460-8877).
There is a new DVPTSR (see fix described in release notes below), you can
get it by sending the following command to ct-user-request@eng.pko.dec.com:
GET dvptsr.zip
There are also two new master callsign files, one is for US/VE only, the
other is DX only with no US/VE. You can get these files by sending the
following commands to ct-user-request@eng.pko.dec.com:
GET masusve.zip ; only US/VE
GET masnous.zip ; only DX
Finally, RELEASE9.TXT has been replaced with the latest version, to get it
send the following command to ct-user-request@eng.pko.dec.com:
GET release9.txt
Remember, all file names must be in lower case!
Here are the release notes for the latest version:
9.23
* This fixes the "walking TS950" problem. IE repeated ALT F4's when the
RIT is on and non-zero, would cause the 950 to move one RIT's worth
each time it returned to the run freq.
* DVPTSR 1.04 has been released. The repeat timer now resets properly
after ESC has aborted a CQ.
* Add an offset to your rotor control with the text command OFFSET. Enter
a positive of negative number. IE +90 instructs CT to send the rotor 90
degrees clockwise relative to the "normal" setting.
* The '+' and '-' symbols in CW messages now work differently. A '+'
embedded in any cw msg speeds up that msg by 5 wpm. A '-' slows it
down by 5 wpm. At the end of the message or after ESC has been pressed,
the CW speed reverts to its value prior to the message. There is
no longer any need to balance '+' and '-' symbols in a CW message.
* FD novice bands, and DXP satellite bands are fixed.
* RTTY RST is fixed.
* VHF contest mode changes adjust the RST properly
--
73 - Jim Reisert AD1C
reisert@eng.pko.dec.com
--
Submissions: ct-user@eng.pko.dec.com
Administrative requests: ct-user-request@eng.pko.dec.com
Problems: reisert@eng.pko.dec.com
|