Hello all,
I am re-furbishing part of the driven element for my 155CA. the element uses
two sections of tubing. The part that goes into the insulator to the boom is 84
inches of 7/8 tubing swaged. No bends. The tip is also 7/8 inch swaged and has
a bend about mid section. My question concerns the tip which was bent on its
way down from the tower. Removing the tip would be quite a problem since no
penetrox was used when it was installed. Does having a slight bend in the tip
really affect its performance?
Thoughts?
Carol
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|