Joel at the RF Connection in Gaithersburg, MD, made me some cables for a
MicroHam controller. The cost was very reasonable.
73,
Mark, KD4D
On November 19, 2016 12:46:55 PM EST, Jim Brown <k9yc@audiosystemsgroup.com>
wrote:
>On Fri,11/18/2016 6:39 PM, AB2E Darrell wrote:
>> If anyone would happen to have 2 sets of Icom cables for the YCCC
>SO2R box they no longer need, I would like to buy them (IC-7800 and
>IC-756Pro III....I think they are the same).
>
>This is part of building the YCCC box. I'm not aware of anyone selling
>them pre-made. The only hard part is finding cables small enough to
>cram
>into that little connector. I used some mini-coax that was a ham flea
>market purchase 15 years ago and some of the better quality consumer
>double RCA cables in my junk box.
>
>73, Jim K9YC
>
>_______________________________________________
>CQ-Contest mailing list
>CQ-Contest@contesting.com
>http://lists.contesting.com/mailman/listinfo/cq-contest
--
Sent from my Android device with K-9 Mail. Please excuse my brevity.
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|