Hi Doug,
With N1MM I usually use two PCs, two Morse Runner instances (one on each
computer), and two keyboards.
For just one computer, DXlog.net allows you to set it up really easy
https://www.youtube.com/watch?v=ifbgmCourKA
For more flexibility, if using just one keyboard you may want to use a
keyboard with plenty of macro keys. So, with a single keystroke you can
start typing in calls in the inactive radio window without switching RX
focus, send Fx memories in the same way, etc. Much like having two
keyboards.
But it depends on how you want to approach SO2R. The latest fashion
seems to be using two computers, two keyboards, software/hardware
interlock with no noticeable delay. Some SO2R controllers have a very
high delay when swtitching audio. That really hurts the rate and the bad
calls total.
As far as audio is concerned, I noticed that complete isolation between
the two channels is not good at all. So, depending on the impedance of
your rigs audio outputs, put a resistor between the two channels to let
a small fraction of the audio drain to the opposite channel. That makes
stereo RX a pleasure. Withouththat, it is not, specially for those of us
who are really far away from EU/USA and JA (increased signal degradation
because of the distance and number of hops).
Hope it helps,
Martin LU5DX
El 10/07/2016 a las 04:09 p.m., Douglas Ruz / CO8DM escribió:
Hi,
Someone know about SO2R simulator.I think it is possible using Morse Runner
and N1MM+ in one PC with 2 keyboards.I need read some instructions about
this topic. It is important for training/practice.
Thanks,
Doug, CO8DM
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|