Hi,
During this week-end CQ WPX contest I recorded my QSOs using the "qsorder"
add-on to N1MM by K3IT.
It is very easy to set-up, the only minor drawback is that there is no
"settings file", so you have to create a batch file to launch it with the right
parameters.
I used a 20 seconds buffer and 5 seconds delay, enough to record the usual
contest exchanges.
Each recording was less than 200kB. For 350 QSOs, it resulted in 30 MB of
files, organized by callsign, band and time. Very neat.
CPU usage on my aging single-core 1,6 GHz Atom was negligible. I did not notice
only slow-down during logging.
Serious contesters would prefer to continuously record their operating,
particularly if they want to use it as a proof in case of investigation by a
contest committee.
I think I will turn it on even when I'm chasing DX as it is "cost free" and can
be useful at times.
As for the radio, the setup on a modern rig like the TS-590s is very simple.
The same USB cable used for CAT control by N1MM also handles the Audio, so no
additional hardware required.
There is just one setting in the TS-590 menu to turn on so you can hear both
the receiver audio and the transmitter monitor.
If not, your transmissions are just blanked.
Thanks Vasily for this nice peace of software!
Only one suggestion for version 3.0 : add a "parameters file" feature.
73,
Yan.
---
Yannick DEVOS - XV4Y
http://www.qscope.org/
http://xv4y.radioclub.asia/
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|