To: | reflector cq-contest <CQ-Contest@Contesting.COM> |
---|---|
Subject: | Re: [CQ-Contest] Feeding an 80m Delta Loop |
From: | Tony Brock-Fisher <barockteer@aol.com> |
Date: | Sat, 10 Nov 2012 20:50:06 -0500 |
List-post: | <cq-contest@contesting.com">mailto:cq-contest@contesting.com> |
To tune a vertically polarized delta loop between CW and SSB, it is only
necessary to add a single piece of wire to the center point of the
bottom leg. The free end should be supported off the ground and the wire
run at right angles horizontally away from the bottom leg.
Feed should be 1/4 wavelength from the apex. Long Haul DX performance will be very good due to low angle of radiation. -Tony, K1KP _______________________________________________ CQ-Contest mailing list CQ-Contest@contesting.com http://lists.contesting.com/mailman/listinfo/cq-contest |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [CQ-Contest] Feeding an 80m Delta Loop, Richard Thorne |
---|---|
Next by Date: | Re: [CQ-Contest] Feeding an 80m Delta Loop, Cqtestk4xs |
Previous by Thread: | Re: [CQ-Contest] Feeding an 80m Delta Loop, Tom |
Next by Thread: | Re: [CQ-Contest] Feeding an 80m Delta Loop, Cqtestk4xs |
Indexes: | [Date] [Thread] [Top] [All Lists] |