If what VE1DT says is true, then ignore my previous message. I'd always
assumed the 4000 was just a beefier version of the BN86 which is a
traditional "wound on toroid" design.
73, de Hans, K0HB
--
><{{{{*> http://www.home.earthlink.net/~k0hb
> [Original Message]
> From: Jim George <n3bb@mindspring.com>
> To: <cq-contest@contesting.com>
> Date: 8/5/2008 11:52:25 PM
> Subject: [CQ-Contest] HyGain BN4000 Balun Question
>
> We will almost certainly be replacing a HyGain BN4000 one-to-one balun
here
> shortly with a WX0B one-to-one balun. It is important to get the "center
> conductor" connected to the same half-element of the driven element in
> order to maintain polarity and phase in a stacked yagi system of 205CAs.
> Can one use an Ohmmeter to check which output lead of a BN4000 goes to
the
> center conductor of the PL259 and which lead to the shield?
>
> Jim George
> N3BB
>
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|