You might do better posting this on the towertalk reflector.
Can you, and did you, calibrate the meter by pushing the CAL
button?
What is the voltage across terminals 3 and 7? It should be
13 VDC. The zener you mentioned is the regulator in the DC
power supply for the meter circuit.
Dave Hachadorian, K6LL
Yuma, AZ
----- Original Message -----
From: "AD5VJ Bob" <rtnmi@sbcglobal.net>
To: "CQ Contest" <cq-contest@contesting.com>
Sent: Friday, June 13, 2008 2:30 AM
Subject: [CQ-Contest] (CDE) HamIV Controller
> The meter on my CDE (HamIV) Controller will only read
> between the N in the middle and the S on the left hand
> side, it will not move
> to the S on the right side of the meter or past the N in
> the middle to the right.
>
> The rotor is turning all the way around and the resistance
> measurements on the leads are good according to the
> manual.
>
> There is a diode VR1 (on schematic) that has a reading of
> POS 5.32 VDC volts on it's cathode and MINUS 6.94 VDC on
> it's anode, the
> schematic in the manual says it should have POS 13VDC on
> the cathode, therefore I am suspecting it is a Zener and
> it is bad, (it is
> not shown in the parts list) although my experience with
> Zeners is they are good or they are bad, does anyone have
> experience with
> this issue with a Ham IV controller?
>
> Power supply voltage off of the controller xfmr is 24VAC
> so this is correct.
>
>
>
> 73 fer nw es gud DX,
> QSL VIA: LotW, BUR, e-QSL
> Bob AD5VJ
> http://www.ad5vj.com/
> Old Calls WB5ZQU, WY5L/KH3, KE5CTY, N5IET
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|