That's Andrew 7/8", right? With the hollow center?
I have used a hacksaw, a utility knife and 2 Crescent wrenches many times.
The Andrew connector usually comes with the little "tool" that screws the
center pin into the cable,
as well as the cutting dimensions and a little ruler printed on the
instruction sheet. Usually.
The only source I use is Tessco.com Full price, I'm afraid. I can get them
at the lowest possible "gold" level,
but can't sell them to you. Sorry. Maybe there is a source of good used ones
or something, I have never wanted
any here. GL.
--
--
73, Craig Cook - N7OR in Sandy, OR
============================
"...then that's a shame on you."
On 7/21/07, kr2q@optonline.net <kr2q@optonline.net> wrote:
>
> HI all:
>
> I picked up some new LDF5-50A at a local hamfest and now I am looking for
> "real" connectors.
>
> 1. Any suggestions on a source (other than full price)?
>
> 2. Can I install these "by hand" or do I need a special tool?
>
> Thanks,
> de Doug KR2Q
>
> PS Gotta keep my qrp signal up to snuff!
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|