I did post this Query on CT Reflector but thought
I'd cover my bases in case someone here knows answer
I have a Celeron machine running DOS/WIN98SE
I am trying to get CT Ver 10.003 set up for a ham friend
Problem is it only has 1 COM port on Mother Board
and I need 2, 1 for Telnet Packet ands 1 for Radio Control
( Using Printer Port to key rig for CW - that works fine )
I managed to find a NEW 2 COM Port ( 2 DB-9s connectors)
PCI board which I installed and the floppy disk that came with it
had drivers for DOS and also WIN98
I did check the company's web site for any new drivers
and the DOS and WIN98 drivers were the same as on the diskette
Machine is set to boot into Straight DOS without
loading any Windows Driver
( set GUI=0 in System.ini file )
That works fine, it boots into DOS on turn on
I installed the card and DOS driver and I am able to
do a port test with a DOS Utility and both COM ports
checkout fine.
In the CT Directory I load
COMTSR1 ( For my Telnet Packet input and that works fine )
I am trying to do radio control for a
Kenwood TS-950 on one of the new ports on the
Plug in serial card
I typed
COMTSRX -A2E8 -B4800
( Where X = 2, 3 and 4 com ports.....to no avail)
Any ideas what I am doing wrong
The Blue confirmation Window always comes up and verifies that
I did in fact get the desired COM port and the port address
( The Serial card booklet instructed me that port addresses
are 2E8 and 3E8
( N81 for other defaults as usual )
I also went into WIN 98 and loaded those drivers just to be sure
WIN98 sees the ports and all is well there but I know not
to run CT for DOS in WIN98
I do NOT want to run CTWIN if I can help it as have
had too many problems in the past with Video chipsets etc
not working correct with CTWIN )
Ant DOS gurus out there with some other solutions ?
73, Dennis N6KI
Sandy Eggo
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|