CQ-Contest
[Top] [All Lists]

Re: [CQ-Contest] Pre tuned Hf amps

To: <cq-contest@contesting.com>
Subject: Re: [CQ-Contest] Pre tuned Hf amps
From: "Peter Voelpel" <df3kv@t-online.de>
Date: Sun, 24 Sep 2006 23:04:07 +0200
List-post: <mailto:cq-contest@contesting.com>
I would never want to change monoband amps to a single or two "autotune"
amps.

Optimized homebrew monoband amps are the far better solution:
- much better components, never bandswitch failures
- better efficieny
- usually better harmonic reduction
- no single point of failure
- more power
- instant switching of bands, no tune at all
- much cheaper

As an alternative, I am in the process of building an additional three band
amplifier for the low bands, 3 Pi-L output circuits, switched in by vacuum
switches and a common input.
No antenna relays necessary since receiving antennas are separate.
This one is to feed additional antennas and will be driven through a ratio
adjustable power splitter.

My amplifiers are not in the shack, except those with radiation cooled
tubes.
I just monitor automatically SWR and overcurrent states which drop the
ptt-line in case of failure, or automatic shutdown of voltages if necessary.

I think this thread will be better discussed in the amp reflector

73
Peter


-----Original Message-----
From: cq-contest-bounces@contesting.com
[mailto:cq-contest-bounces@contesting.com] On Behalf Of Eric Hilding

> I'am looking for some information to put an hf amp in an other room I 
> thinking to build monoband amps who are pre tuned and no need to 
> retune if you go from ssb part to the cw part of the band.
>
> Has any one done ths before?
> How do you make the protection/feedback to the operator if something 
> goes wrong?

Why re-invent the wheel?  Get ***ONE*** "Auto-Tune" amp.  ACOM, ALPHA or
check out the new Elecraft KPA amps ("coming soon" :-)


_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest

<Prev in Thread] Current Thread [Next in Thread>