>-----Original Message-----
>From: cq-contest-bounces@contesting.com
..
>David Pruett
>Sent: 12 December, 2005 05:54
...
>
>50 ohm in ]================={}=================[ 75 ohm load
> .0818w .0818w
> 75 ohm 50 ohm
>
>Because there are frequency-specific lengths of coax involved,
>it's obviously a single-band system. I've had these for
>almost two decades at K8CC with no failures. No ferrite
>involved, but you do tend to get a lot of practice installing PL-259s.
>
...
>73,
>
>Dave/K8CC
?
What for do you need the many connectors?
Just solder the coaxes and use one connector at each end of the line
i.e. at 50 ohm points.
Or did I mis-understand this somehow?
73,
Jukka OH6LI
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|