I apologize for this not being exactly on topic, but I could not find
either an Ameritron or an Amplifier reflector listed on QSL.net.
Back in March I pulled my TS-950 out of my station to take it to a multi
two operation for ARRL DX Phone. When I brought it back I put the station
back together before I had had enough sleep apparently and I connected the
output of the 950 to the output of the 811H (and connected the antenna to
the input of the 811H). Everything worked just fine with the amp in
standby - but when I turned the amp on and keyed the 950 I could
immediately see that there was a problem!! Unfortunately I tried keying
the rig two more times before it dawned on me to check if I hooked the amp
back up correctly.... After getting the connections right I tried it out
and the SWR seen by the 950 into the 811H was not good. I can switch bands
and the SWR looks good (I have not done a systematic trouble shooting of
this yet). I did not have time to dig into it at the time, and I have not
used the amp until last night. I again have poor SWR on 20M, but SWR is
perfect on 40M (this is what the 950 sees going into the 811H), and I
believe that 10M is good from the last time I was trying to figure this
out. I printed out the schematic and took a quick look, but it is not
drawn in a format that makes it easy to quickly see what the circuitry is
looking into the RF out port.
So my questions are: Does anyone have a recommendation on the best way to
check out the amp (other than the obvious of put power in on each band, and
look at SWR and Pout). What is the mostly likely component(s) that I damaged?
Thanks to all who respond.
73 de W2RDS,
Rick
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|