This is 100% correct.
Hams should be able to do their own electrical work -
shouldn't we ?
If we can work on amplifiers with high voltage power
supplies etc., we should be able to handle this "low
voltage" stuff.
With that said, I would strongly suggest that if anyone
has any doubt how to proceed and how to do the work in
compliance with code, you should not begin the work at
all. Contact your local electrical inspector for advice
and guidance.
As Jim says, many inspectors are helpful - some are
not. If you determine that you need professional
assistance, the inspector can probably provide you with
a list of reputable electricians in your area.
With electricity, if there's any doubt - don't !
73,
Bob N5NJ
>
>
> From: James P. Cassidy, 107770,3462
> TO: CONTEST REFLECTOR, INTERNET:cq-contest@contesting.com
> DATE: 3/15/99 7:52 PM
>
> RE: Copy of: Shack power
>
> The installation of additonal power wiring, and the assurance that its done
> correctly, can be maintained by obtaining the required electrical permit
> and subsequent sign off by the electrical inspector. With the signed off
> inspection it is relatively safe to assume that there would not be any
> future problems with either the installation of the insurance coverage on
> it.
> In most jurisdictions the home owner is allowed to do his own work as long
> as it meets the local code. The National Electric Code is not the final
> answer, many local jurisdictions have their own set of standards based on
> the NEC.
> In some instances the local inspectors can be helpful with their advice, I
> have heard of others that are not as friendly with work installed by
> non-licensed people.
> 73 Jim KI7Y
>
>
> --
> CQ-Contest on WWW: http://www.contesting.com/_cq-contest/
> Administrative requests: cq-contest-REQUEST@contesting.com
>
--
CQ-Contest on WWW: http://www.contesting.com/_cq-contest/
Administrative requests: cq-contest-REQUEST@contesting.com
|