Gang,
My friend UT5URF owns used Kenwood TS940S/AT, which has the following
problems:
1) Sometimes when he switches it ON, the display begins to show
" . . . . . . . . . ."
instead of frequency. It appears 1-2 seconds later after switching
the POWER button ON. There's no receive at this time, only IF noise in
headphones. One must switch the RIG ON and OFF from 5 to approx. 30 times
to get it ready.
2) When CW VBT or SSB SLOPE TUNE is not in the normal position, there's a
frequency shift while pushing and releasing SEND/REC button. This can be
also heard while operating SSB and listening to yourself in headphones
("MONI" ON).
Any advise will be greatly appreciated. Please direct replies to:
<jerry@ut4uz.isf.kiev.ua>
Sorry for bandwidth.
Happy Holidays and Happy New Year to everybody!
73! "Jerry" UT4UZ / N2WCQ
--
CQ-Contest on WWW: http://www.contesting.com/_cq-contest/
Administrative requests: cq-contest-REQUEST@contesting.com
|