On Fri, 14 Nov 97 21:22:13 EST frenaye@pcnet.com writes:
>
>for K6LA -
>
>There's an 1/8" audio output plug on the back of the TS850 (and most
>other
>transceivers). I think when you use it the audio is cut to the front
>panel audio jack though so you'll have to make up a "Y" cable"
>
> /--------- 1/4" phono female to
>headphones
> TS-850 /
> 1/8"male ----------------
> \
> \--------- RCA male to VCR
>
>
>This is the same cable used at WRTC-97 so a VCR could be hooked up to
>record the action...
> 73 Tom
>
Almost.
I found a 220 ohm resistor in the VCR audio line provided better noise
immunity.
Also, two 100 ohm resistors were in the headphone jack, in series with
the L and R channels, to allow use of either mono or stereo headphones
without shorting the works.
73 de Bob, K6XX
--
CQ-Contest on WWW: http://www.contesting.com/_cq-contest/
Administrative requests: cq-contest-REQUEST@contesting.com
|