Thanks for confirming my thoughts on using the 25g base for 45g. Most ideas
were some version of using a 25G beacon plate and attaching it to the 25G
followed with drilling a whole in the middle for the pin. Or taking a 45G
concrete base plate and drilling holes in it so it will fit over the 25G
base. All the ideas were great, so when I go to 45g I don't need to dig a
new whole.
As far as surge surpressors I installed a GE type, don't have the part number.
It was a 5 minute job. The surpressor mounted in one of the wholes on the
pain panel. I had the electric company come out to disconnect the meter to
remove the power. The did that for free. Took my hex wrench installed the
3 wires from the surpressor and it was done.
Now will it work? or will I know that it worked? I'll never know, unless I
loose some electronic equipment via the ac lines. Then I'll know it didn't
work. By the way the unit cost me $45. My dad and I ordered a couple of them
to install at both of our houses. Shipping was extra.
73,
Rich - WB5M - RTHORNE@VNET.IBM.COM
|