Dear Bob, Guy and Martin,
Thank you all for your help and advice. Your input is highly appreciated. I
will get back to work with the ATU implementing your suggestions.
Best regards and a happy new year.
Paris 5B4XF
-----Original Message-----
From: antennaware-bounces@contesting.com
[mailto:antennaware-bounces@contesting.com] On Behalf Of Paris Andreou
Sent: Friday, December 26, 2008 3:44 PM
To: antennaware@contesting.com
Subject: [Antennaware] RF relay switching problem
Hello all.
I am not sure if this question applies to the list, but if any of the gurus
out there can help, it would be much appreciated.
I have built a remote ATU to use at the base of a 66-foot vertical. The
antenna is resonant on 80m and I have built 2 L-networks to feed the antenna
on 40m and 160m (one for each band). The networks consist of overrated
roller inductors and air-spaced capacitors. Networks work fine at high power
when used on their own or switched using big rotary switches.
I bought big relays rated at 10KW to switch the networks. The relay control
cables and coax go from the shack to the base of the antenna about 1 metre
below ground. The problem is that at high power there is arcing and relay
coil overheating. I cannot tell exactly where the arcing occurs, but it
appears that RF is coupling into the relay frame/coil or arching between the
contacts and the coil.
I have added a diode and 0.01 uF capacitor across the relay coil, but this
has not solved the problem.
Has anyone come across a similar problem? Is my suppression circuit
inadequate? Does the position of the ATU box matter (eg bury below ground)?
Thanking you in advance,
Paris 5B4XF
_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware
_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware
|