At 11:15 AM 10/19/98 -0700, Eric Gustafson wrote:
>
>
>Does anyone have or know of any single conductor diameter
>equivalences to use in models of system involving towers?
>
If you have access to the June 1998 issue of IEEE Transactions on
Broadcasting, check out the article: "A Method for Modeling Array Elements
When Using NEC and MININEC" by J.L. Smith. The author discusses methods
for modeling towers and in particular, describes a single-wire
representation for a triangular cross section tower. His result is that
the radius of the equivalent wire equals the cube root of the quantity
(D*F^2)/2 where D is the diameter of each tower leg and F is the width of
the tower face with all dimensions in the same units. Some references are
cited to justify this result.
73, John W1FV
--
FAQ on WWW: http://www.contesting.com/antennaware-faq.html
Submissions: antennaware@contesting.com
Administrative requests: antennaware-REQUEST@contesting.com
Problems: owner-antennaware@contesting.com
|